"Harry" wrote in message
...
In article ,
says...

"W1TEF" wrote in message
...
On Mon, 28 Jun 2010 16:58:47 -0400, W1TEF
wrote:

On Mon, 28 Jun 2010 16:47:34 -0400, wrote:

On Mon, 28 Jun 2010 16:00:55 -0400, Harry
wrote:

In article ,
says...

"John H" wrote in message
...
Ran across this while muddling in the garage. Couldn't, for a
while,
figure out
what the hell it was.

Can you?

http://i98.photobucket.com/albums/l2...g1/whatamI.jpg


--
Calling an Illegal Alien an "Undocumented Worker" is like calling
a
Crack Dealer an "Unlicensed Pharmacist"

John H

Looks sort of like the old tire bubble balancer. But no level on
the
top.

Because I don't do any mechanical work of any kind, even though I've
taken mechanical engineering courses, I shouldn't know what that is.
BUT, I watched my mechanic doing the maintenence on my push
lawnmower.
That object is to balance the lawn mower blade after sharpening.

I am not sure which Harry this is but the answer is right.

I'm curious - how do you balance a blade after sharpening?

Well I'll be danged - never thought of balancing the blade after
sharpening.

http://www.amazon.com/MaxPower-33907.../dp/B000FJTVSI

Never mind. :)


I didn't know there was a do-dad for home handymen to use.
I always balance my blades on a screwdriver shaft. It the two sides can
point east & west, I've taken the right amount off each side.

Maybe they don't have such modern sophisticated and refined things up
there, little buddy. I sure am glad you're back, I was getting raked
over the coals by people that just don't believe the amazing things I
and my parents have done. Except you. You believe me, huh?


I believe you are a very unsuccessful spoofer.