"I am Tosk" wrote in message
...
In article m,
says...

"Eddie" wrote in message
...
On Sat, 12 Dec 2009 23:55:59 -0500, Rob wrote:

Eddie wrote:
I have a Regal, dry weight around 8,200lbs. It sits on a three-axle
trailer, weight approx. 1,500 lbs. I have six so-so tires and will
have the boat sitting on a cement pad for the next 6 mo. or so doing
some major and minor work on it. I'm thinking that with all that
weight on the tires that if they lose air I may have a hard time
putting air in them where it sits. I suppose I could call AAA and
ask
for a truck that has an air compressor. So my question is, could I
put a couple of floor jacks to help support the weight of the boat
and
trailer? I've seen where cars that are stored for a long time have
something to remove the weight under the car. Has anyone done this?
I'm thinking that I'd need minimum four with each having a 2-ton
capacity. I'd have to figure out a way to lift the boat up to slide
the jacks under it.
Any comments or suggestions appreciated.
Eddie


It can't hurt to keep then from developing a flat spot. They also sell
covers to keep the sun from deteriorating the rubber. I see RV with
these frequently.

A good floor jack and some stacked 4X4 wood blocks (or jack stands)
will
do the job.

Rob
Rob, think there's a floor jack out there that will lift 10k pounds? I
know the pros have 'em, but I was thinking of either borrowing from a
neighbor, or buying one at Kragen's.
Wonder which is cheaper to buy, 4X4 wood or jack stands?
As for the tire covers, good idea, I have them for my TT. Online from
WalMart. Will get some as soon as I find out the tire size.
Thanks!
Eddie
What Wayne said and:
http://www.harborfreight.com/cpi/cta...emnumber=66725
and
http://www.harborfreight.com/cpi/cta...emnumber=38846

The big problem with those jackstands is they are not stable on black
top, they must be used on cement or similar or the edges can dig in and
spill over. This is much more dangerous in the summer months. REad up
before using them for anything you are going to be under or you don't
want to fall over.


Yeah, that would suck - saved the springs and tires but the boat sank in the
parking lot!
Eddie wrote that it'll be stored on a concrete pad.
Could probably get some weight off by lowering the tongue (trailer jack),
placing concrete blocks/boards/etc just behind the rear spring hangers and
then raising the tongue.