"Eddie" wrote in message
...
On Sat, 12 Dec 2009 23:55:59 -0500, Rob wrote:

Eddie wrote:
I have a Regal, dry weight around 8,200lbs. It sits on a three-axle
trailer, weight approx. 1,500 lbs. I have six so-so tires and will
have the boat sitting on a cement pad for the next 6 mo. or so doing
some major and minor work on it. I'm thinking that with all that
weight on the tires that if they lose air I may have a hard time
putting air in them where it sits. I suppose I could call AAA and ask
for a truck that has an air compressor. So my question is, could I
put a couple of floor jacks to help support the weight of the boat and
trailer? I've seen where cars that are stored for a long time have
something to remove the weight under the car. Has anyone done this?
I'm thinking that I'd need minimum four with each having a 2-ton
capacity. I'd have to figure out a way to lift the boat up to slide
the jacks under it.
Any comments or suggestions appreciated.
Eddie


It can't hurt to keep then from developing a flat spot. They also sell
covers to keep the sun from deteriorating the rubber. I see RV with
these frequently.

A good floor jack and some stacked 4X4 wood blocks (or jack stands) will
do the job.

Rob
Rob, think there's a floor jack out there that will lift 10k pounds? I
know the pros have 'em, but I was thinking of either borrowing from a
neighbor, or buying one at Kragen's.
Wonder which is cheaper to buy, 4X4 wood or jack stands?
As for the tire covers, good idea, I have them for my TT. Online from
WalMart. Will get some as soon as I find out the tire size.
Thanks!
Eddie
What Wayne said and:
http://www.harborfreight.com/cpi/cta...emnumber=66725 and
http://www.harborfreight.com/cpi/cta...emnumber=38846