dh@. wrote:
I'm trying to take apart a Mercruiser outdrive to replace the boots
which have cracked. It looks a good bit like this one:
http://www.boats.net/_search/images/...4198540716.png
I had to go buy a 1/2 inch allen wrench to remove part #26. They're
very tight, possibly rusted, and I haven't broken them free yet. Is
there anything else holding them, or should I get a cheater bar and
apply a lot more force to break them loose? Any suggestions about this
job would be much appreciated.
Thanks!
David
They are usually held with locktite and torqued to 90 or 100 ft lbs. You
should use a special 12 point tool instead of an allen wrench.