Go over to rec.crafts.metalworking and post your question there. While the
group is nominally about metalworking, the machinists there know a lot about
the machining characteristics of various materials like the plastics.

Tom Dacon

"Geoffrey W. Schultz" wrote in message
. 16...
I have a KISS wind generator that develops vibration at certain wind
speeds. The problem is that there's a PVC fitting that goes over a 2"
stainless schedule 40 support pipe that is loose fitting. I want to
machine one with a sleeve bearing on a lathe and make it out of plastic.
However, I really don't have any experience machining plastic, I've been
looking at www.mscdirect.com under Raw Materials/Plastic Material/Rods for
3" material. To keep costs under control I'm looking at the following:

Nylon
Acetal
UHMW
LDPE
HDPE

Comments on the machining qualities, UV resistance, and overall strength
of
these would be greatly appreciated.

-- Geoff