I don't know if this CO. has any bushings the size your looking for. But
you may want to check
http://www.apfp.com/pdf/spacers.pdf
Jack
"Geoffrey W. Schultz" wrote in message
. 16...
I have a KISS wind generator that develops vibration at certain wind
speeds. The problem is that there's a PVC fitting that goes over a 2"
stainless schedule 40 support pipe that is loose fitting. I want to
machine one with a sleeve bearing on a lathe and make it out of plastic.
However, I really don't have any experience machining plastic, I've been
looking at www.mscdirect.com under Raw Materials/Plastic Material/Rods for
3" material. To keep costs under control I'm looking at the following:
Nylon
Acetal
UHMW
LDPE
HDPE
Comments on the machining qualities, UV resistance, and overall strength
of
these would be greatly appreciated.
-- Geoff