Not needed in this case. I had a crew of big healthy UGA students to
operate the hauser. They run on beer pressure. :-) Actually by
dragging the hauser back to the cockpit once it hung on the front of the
fin got everything down to about 18" above the keel.
OTOH, it would probably not work for a wine glass full keel hull. A
couple of fenders covered in scotchbrite or such and tied into the line
might get the hollows.
Larry W4CSC wrote:
I'd also think that method would work better if there were some kind
of floatation along the line that would cause the line to press up
against the hull as the floatation tried to get to the surface along
the hull's surface.
Would that help?
On Tue, 04 Nov 2003 17:44:15 -0500, Glenn Ashmore
wrote:
The recent threads on bottom cleaning reminded me of something we tried
on a charter in the BVIs last summer. We had picked up a Beneteau 41 at
Nanny Cay. Nanny Cay marina has very poor circulation and it was
August, late in the season. We soon found that the bottom was fast
becoming a marine wildlife perserve. One of the crew found about 40' of
old ragged 1" hemp hauser in the dry storage yard. The kind that makes
your hands hurt just looking at it. The first night we stopped on the
back side of Peter Island. It was out near the point at White bay where
there was a fair westward current.
We looped the hauser under the bow and worked it back past the keel
pulling it back and forth from side to side. Then we did the same from
the prop forward and again from the prop back to the transom. Produced
a great cloud of green slime and blue ablative bottom paint. It took
about half hour of hard work but except for a small triangle over the
keel and a strip above the prop shaft the bottom was spotless. The
rudder and keel were a different matter but what the heck. It was an
off season rental. At least we got some decent speed out of the boat
after that.
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com
Larry W4CSC
"Very funny, Scotty! Now, BEAM ME MY CLOTHES! KIRK OUT!"
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at:
http://www.rutuonline.com
Shameless Commercial Division:
http://www.spade-anchor-us.com