Wash it thoroughly with hot soapy (detergent) water to remove contaminants
and rinse very well, then sand it down and wash with warm ammonia water,
then try coating again.
Brian D
--
http://www.advantagecomposites.com/tongass -- My 22' Tolman Skiff project
..
"jleiby" wrote in message
...
It looks exactly like that!
"Meindert Sprang" wrote in message
...
"jleiby" wrote in message
...
I didn't rinse off the amine blush in the beginning because I was
under
the
impression that if you recoated with-in a day or two it was not
necessary.
Also, the epoxy I used is very low blush and I didn't notice any. I
since
have attempted to wash the surface with warm water but it didn't make
any
difference.
Mmmm..... interesting. I have never figured out why this was happening.
Did it look like this?
http://www.customware.nl/boats/images/sep/10091.jpg
Meindert