BoatBanter.com - View Single Post

ospam (Stephen Baker) wrote in message ...
Parallax says:

snip

Also remembered that failure to properly countersink some screws on
the hull caused substantial delays in the finishing of #1 so I spent
several hours removing most screws countersinking more and replacing
to make sure they were really below the surface on #2.

ahhhhhh..... my favourite problem (as in the one I do most often) I don't
feel alone any more ;-)
I do find, however, that it is only really a problem in hardwoods, since I
usually underdrill the holes at the same time, making it inevitable that the
head shears off when I try to back it out to increase the 'sink.

Steve "now you know why I design 'em, not build 'em..."

More progress on #2. Got rear deck glued and screwed on. Forward
deck was screwed on for fitting purposes. I found that wet ply (it
has been raining every day) bends FAR easier than dry. I dont seem to
have enough floatation peanuts and milk jugs and soft drink containers
to fill the bow. Hmmmm...
More progress on trailer but the dimensions given on the internet for
the Northern Tool site are wrong. It is NOT 4' wide but is only about
3.5' wide, serious modification needed but I got an idea.