View Single Post
  #7   Report Post  
posted to rec.boats.cruising
Skip Gundlach Skip Gundlach is offline
external usenet poster
 
First recorded activity by BoatBanter: Jul 2006
Posts: 540
Default Nylon vs brass vs bronze vs Marelon (was) Miami Passage - Day 7 - October 14

"Roger Long" wrote in message
...
"Michael Porter" wrote

But watch brass (as opposed to bronze) fittings carefully -- athey
are
subject to turn into red dust in salt water. Just keep a close
eye.


I'll more than second that. Since this is a raw water line and
operated at elevated temperaturs due to being in a cooling circut,
it absolutely should not be brass. Even though it won't sink the
boat if it breaks, water rising in the bilge could be a dangerous
distraction in a difficult situation. The breakage would also be
accompanied by exhaust leaking into the interior of the boat. You
won't be able to keep a close enough eye on the interior of the
fitting where the problems will be.

Even if this is just a seldom used overflow that seldom sees salt
water, it's still exposed to exhaust gas on the other engine cooling
water.

This is the place to invest in bronze. Brass should only be used in
F.W. and fuel lines.

--
Roger Long


Well, you'll all be thrilled and comforted :{)) that today I bought
another nylon fitting, as there were no bronze or Marelon fittings
available. Next on the boat chores list is to replace the entire hose
to which the leaky fitting fed, as it's getting old, at the same time
as I replace the fitting. No pressure on it, but I have plenty of
fuel hose, which is the same size, and as I'll route it so as to have
no side pressure on it (as was the case in the broken fitting), I
expect that will last the life of the boat as we own it, since I
speculate what was there was original :{))

Meanwhile, I spent two hours on the silty bottom of the Frederica
River today, after spending about 5 hours in the other Angel's boat
doing hoses, rescuing an anchor and setting up a mooring, from the
first Angel's couple-year ago loss by fouling on a huge lead cylinder
with 6 INCH chain on it. Every bit of it by feel, as there was ZERO
vis, even only ~10' down. More boat work in the first one tomorrow,
and then I'll deal with my own boat's 1-2-3's (small daily chores)...

--
L8R

Skip

Morgan 461 #2
SV Flying Pig KI4MPC
See our galleries at www.justpickone.org/skip/gallery !
Follow us at http://groups.yahoo.com/group/TheFlyingPigLog
and/or http://groups.google.com/group/flyingpiglog

"You are never given a wish without also being given the power to
make it come true. You may have to work for it however."
(and)
"There is no such thing as a problem without a gift for you in its
hands. You seek problems because you need their gifts."
(Richard Bach, in The Reluctant Messiah)