Thanks for the advice.

I am using a female mold, the first layer will be a thin veil, it can
be used with epoxy, I have check this with the manufacturer. I will
not be using a wooven cloth it will be a biaxial, but yes print
through perhaps will be a problem. I was planning on just epoxy
painting it after I pulled it from the mold but many people tell me
that the epoxy will not release as easily as using a gel coat. So the
problem for me might be a way to be assured that I can get the hull to
pop from the mold. I will check out the link, for the epoxy gel coat,
thank you very much.