formica trim finish technique.
About the only formica work I have done has always had lee rail or edge over
it.
I'm building a drop leaf cabin table that will have a formica top with teak
rails around it.. No problem there. The table top base material is 3/4" ply.
However, I want to add 3/4"X3/4" edge where the the drop leaf joint will be.
I want to trim this teak down so it will be finished flush with the formica.
I can't plane or sand it flush without scoring the formica surface.
I'm thinking use the rotor with a flush trimming bit (which has a guide
bearing).. My question would be, will the guide bearing cause any marks on
the formica surface?? Is there something that I should put on the formica
surface (wax, etc) to prevent burn marks or scoring??
Opinions, suggestions or experiences.
Steve
s/v Good Intentions
|