Watching boats in chop
On Aug 17, 1:45*pm, hk wrote:
wrote:
On Aug 17, 1:35 pm, wrote:
On Aug 17, 1:29 pm, wrote:
Yesterday, i was at St. Andrews State PArk near Panama City, FL siting
on the jetty watching boats going in and out between the jetties. *The
tide was going out with s little wind opposing it so there was a good
chop in the channel. *It was a great venue for watching how boats are
handled in chop.
About 1/4 of the boats were clearly going too fast for conditions and
eventually they would pound too hard and slow down. *About 1/4 were
going too slow and were wallowing in the deep chop. *What did amaze me
was the number of small boats with transoms cut away so much that if
they slowed down their own wake would swamp them. *These boats had
transom tops only inches from the water and seemed to have no business
in such chop.
My Tolman is the first power boat I have ever driven so I have no
other basis for comparison. *What degree of pounding is acceptable?
According to at least one person here, getting swamped from following
seas because of a low transom is the way it should be.
I suspect HK thinks I am trying to weigh in on some controversy over
cut-away transoms but I never kept track of who was in who in that
one.
I suspect the Tolman is stronger than most Fiberglas boats and I have
never heard of this happening so his answer is useless. *Any other
answers on how much pounding is too much?
My answer is correct: it depends upon the strength of the boat and the
fortitude of its occupants. Beyond that, it is a meaningless question.
BTW, if your Tolman is a homebuilt wood boat, it unlikely is "stronger"
than most properly built fiberglass boats of the same size. I could tell
you why, and in some detail, but...what's the point, eh?- Hide quoted text -
- Show quoted text -
Sure, go ahead Harry. Have you ever seen his boat up close? What do
you know of it's construction?
|