At those prices, he should have gotten the development capital back by now..
However I'm supprised they are still selling parts.. Not something you see
now-a-days.
I'm happy with my (chinese made) Newfound Metals bronze ports.. I have 8 of
them (paid less than $100 each) and not a leak or complaint. BTW. The owner
of Newfound Metals goes to China each time their going to mfg a batch and he
provides the Quality Control plus he does a final inspection/test on each
port when it arrived at his shop.. I've been there a few times and seems
like a 'tight operation'.
--
My opinion and experience. FWIW
Steve
s/v Good Intentions
"Glenn Ashmore" wrote in message
news:4TWLb.31624$JD6.25962@lakeread04...
I bought one as a sample several years ago when I was choosing hardware.
They are actually extremely high quality. The story goes that Mr.
Fuller got very upset with the leaking portlights on his yacht and sent
one to his engineering department with instructions to make one that did
not leak. It was not originally intended to be a production item so
only two size molds were made to fit the requirements on his boat.
Apparently the engineers took their boss's instructions to make sure
that they did not leak quite seriously but Mr. Fuller failed to mention
a budget. The cost ran so high that he had to proclaim them a product
so the development cost could be written off. Thus the Fuller Brush
Company got into the portlight business.
Steve wrote:
Surprise Surprise!
I was surfing misc.consumers.frugal-living NG and saw a post from a semi
retired Fuller Brush salesman (http://www.MyFullerBrush.com).. I
couldn't
resist asking if they still sold port holes..
http://www.fuller.com/products_subca...at=2&subcat=11
You guessed it.. They not only still sell two different size port holes
but
they still sell parts for them as well..
Their prices are pretty high, compared to the bronze ports from New
Found
Metals of Port Townsend WA but I know the Fuller Brush ABS plastic ports
have been around a long time.
No, This is not a troll or spam.. Just a bit of curious information.
Steve
s/v Good Intentions
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com