Has anyone sucessfully built a boat out of unfolded panels from this hard
chine design program?

I set up stations and made a cardboard scale model of a boat by wrapping
the cardboard around some frames, marking, unfolding, and cutting. Then I
put the offsets into the Carlson program and used the "Patterns/Nesting"
feature to arrange the panels on sheets of plywood and print out points
for hand plotting. I plotted and cut the panels from cardboard, same scale
as the model, and taped the cutouts togehter sticth-and-tape style. The
result isn't the same as the model. There is a big gap at the stem, the
topside panels are 25% wider, and the it just doesn't fit the frames.

(I've been back seeing if I can alter the offests to get a better fit and
find the auto spline makign S-curves in the keel at the stem. Very strange.)

Am wondering if others have got good unfolded panels from the program.

(The boat is the 15ft solo cruiser design I've been documenting under
"Boats" on my website.)


--
------------------------------------------------------------------------------
William R Watt National Capital FreeNet Ottawa's free community network
homepage: www.ncf.ca/~ag384/top.htm
warning: non-freenet email must have "notspam" in subject or it's returned