On Fri, 28 Nov 2003 15:24:18 GMT, "Jim Bailey"
wrote:

I've recently replaced the side windows in our 66 34' Hatteras. I now have
a lip, approx 1/4 - 3/8" around the inside edge (inside the salon) that I
need to trim out. If it were all straight, some simple "L" shaped wood
molding would be fine but I have a couple of radiuses to deal with - the
photos below should help you envision what I mean- the problem areas a




I'm not sure how to deal with this. Any ideas ? Any source for a molding
that might be flexible enough for this job ?

You have to cut the corner pieces to fit. First get a chunk of wood
long enough for corner. Should be flat grain. Cut the outer edge to
fit. At this stage you can do several attempts to try and fit. You
might try to get a tracing of corner by tape a piece of paper to
corner region and rubbing with a pencil. In your case you would add
the "leg" of the L. Cut that rabbet with router or shaper. When the
fit is perfect on the outer edge, cut the inner edge. Obviously the
piece is now very fragile; thus the requirement for flat grain.
Radius the corner as required.

These instructions are minimal, I know, but they should be sufficient
to suggest the method.

Nice boat, by the way.

Regards,
pcf