If the resin is warm, it flows more easily.

"James W. Sloan" wrote:

Yes it can be done. A lot depends on the void, hole, or whatever you're
trying to fill. I've used WEST Microfibers with slow hardener through a
syringe. It is something of a trial and error process, buy at least a few
syringes to spare. I had good luck using a single pump of each
(resin/hardener) and about 3 heaping teaspoons of the microfibers. Try first
with 2 spoonfuls and see how your consistency is doing, then add the third
if needed. You'll have to trim the syringe tip to make it a little wider,
again this depends on the size of the hole. I cut mine at an angle about 1/3
up from the tip to fill screw holes, further up for a bead of the mixture.

Good Luck,

James