Brian Nystrom wrote:
Glenn Ashmore wrote:
That is about right for Proset 125/229. FGCI laminating resin is
about half that price but about twice the CPS (they don't state any
number but that would be my estimate.) Raka is even thicker.
Really? I haven't used it yet, but everything I've heard about Raka
is that it's one of the lower viscocity epoxies on the market. It's
supposed to provide very rapid wet-out.
That has definitely NOT been my experience. I use Proset and West most
but have used Maas, S3 FGCI and Raka. Raka was the thickest. The Maas
low viscosity resin was probably the thinest.
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at:
http://www.rutuonline.com
Shameless Commercial Division:
http://www.spade-anchor-us.com