I am beginning to wonder if locally built aluminum tanks are a good
idea. Every shop around here is tooled up for 6061 but marine tanks
need to be 5000 series. I will have to supply my own 5086 and TIG
welding rod and the best price I can find is in New Orleans. $130 a
4x10 sheet plus about $100 shipping. Still, a lot better than $300 a
sheet in Atlanta but not as good as $65/sheet for 1018 mild steel locally.
If I go with aluminum I think I will have to machine my own fittings.
There are very few sources of 5000 series aluminum fittings and the
selection is limited. It will be fairly simple to mill and tap some
NPTF fittings from 1" round for welding onto the tank.
I would like to hear some discussion of mild steel vs aluminum. Total
cost of mild steel tanks is about half that of aluminum but weighs about
twice as much. In this case a pair of custom 40 gallon would cost $600
in aluminum with some effort on my part to get the alloy vs $320 for
mild steel and weigh 72 pounds vs 125 for steel. From what I hear, a
well painted and installed steel tank will last just as long as
aluminum. Longer if the aluminum is not properly installed.
Ron White wrote:
I had my aluminum gasoline tanks built by Ezell Industries one of the three
marine tank builders in Perry Fl. I let them decide where the baffles were
( a wise move) also they provided the tank fitting and valves which some of
need to be al. rather than ss or brass. One thing to consider also is the
pickup tubes, they made these with nylon? tubing swaged onto the al tank top
fittings. Some other people I talked to were not up to speed on the issue of
not using metal pickup tubes as they are subject to vibration and fatigue.
Wouldn't want the pickup to break!!! I was very happy with Ezell and the
good work they did.
Then Painting, which I did. This system is my standard and I use it on any
alum. thing I make for boats.
1, clean with acid ectching solution ( like, Ditzler DX533)
2 prime with dupont Variprime 615S self etching primer.
3 finish with several coats of 2 part epoxy primer.
For exposed alum. things, add about three finish coats of a urethane
enhanced enamel like Limco 1234.
All of the products are availble from automotive distributers I think the
key is using the variprime as is bonds to aluminum like nothing else I know
of..
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at:
http://www.rutuonline.com
Shameless Commercial Division:
http://www.spade-anchor-us.com