View Single Post
  #9   Report Post  
William R. Watt
 
Posts: n/a
Default Steam bending basics??

I've done something similar with a polytarp envelope but do not know how
hot it can get. What I got was warm moist air which was okay for the
gunwales I wanted to bend a bit more than they were willing to go dry. I
laid the polytarp on some plywood between two saw horses, put blocks a bit
higher than the camber of the bend I wanted at each end, laid the gunwale
stock on the blocks, folded the polytarp over, and "steamed" until I could
push the gunwales down to touch the plywood, put some weights on the
gunwales to hold them in that bent position, turned off the steam, and
left things like that overnight. In the morning I unwrapped everything and
had my bent gunwales.

"fraggy" ) writes:
hi
my boatyard puts the wood in a long bag made from sail cover material and
inserts the steam cleaner lance and just leaves it on full blast for about 1
hour per inch

fragged
"steamer" wrote in message
...
--Looking to see if someone's got a technique or guidelines to
follow; i.e. how long to steam a particular wood with a certain thickness.
Are there tables for this sort of thing?
--TIA,

--
"Steamboat Ed" Haas : Quando Omni
Hacking the Trailing Edge! : Flunkus Moritati
http://www.nmpproducts.com/intro.htm
---Decks a-wash in a sea of words---





--
------------------------------------------------------------------------------
William R Watt National Capital FreeNet Ottawa's free community network
homepage: www.ncf.ca/~ag384/top.htm
warning: non-freenet email must have "notspam" in subject or it's returned