View Single Post
  #4   Report Post  
posted to rec.boats
nfisherman nfisherman is offline
external usenet poster
 
First recorded activity by BoatBanter: Feb 2008
Posts: 2
Default pitot tube on Yamaha outboard

On Feb 18, 4:22*pm, Short Wave Sportfishing
wrote:
On Mon, 18 Feb 2008 13:57:19 -0800 (PST), nfisherman





wrote:
On Feb 18, 3:45*pm, Short Wave Sportfishing
wrote:
On Mon, 18 Feb 2008 08:01:05 -0800 (PST), nfisherman


wrote:
My speedometer is not working. *I have narrowed the problem down to
the inlet for th pitot tube in the gear case. *I have removed the gear
case and when I put air pressure on the tube toward the dash, the
speedo needle moves. *I cannot blow air in the other direction into
the gear case. *It's plugged tight. *I can't see any clogged holes on
the exterior of the gear case. *Does anyone have any suggestions
before I give up and live with my GPS for speed?. *I know the GPS is
more accurate anyway, I just like to have all of the console gauges
working.


I've seen this before, but not on a Yamaha.


What's probably happened is the tube from the pitot intake is blocked
or pinched - more likely blocked by crap - salt, mud, sand, etc.


The best way to clear it is to use thin SS wire - like trolling wire -
or, the way I did it on an old Evinrude, SS welding wire - the
thinnest you can get which is pretty thin.


Either that or grab a air hose and use pressure to clear the line.


I think you're probably right, but I can't find the block. *The
blockage is definitely in the gear case. *I have removed the rubber
tube from its connection and I have poked a wire in there. *It goes in
about 8 inches and stops. *Next, I poked a wire in the hole on the
outside of the gear case, which I think is the one for the speedo. *It
stops about one inch in and then when I push harder, it goes in for
about a foot. *It feels like it makes a bend and then it's just open
space in there. *After all that, I screwed the barb fitting back on,
connected a hose and blew in air. *It's still blocked. *I'm stumped.


Well, I'm out of ideas beyond it being pinched.

Sorry.- Hide quoted text

- Show quoted text -


Thanks for trying. I put 100 PSI of air on it and it didn't budge. I
am now trying some acid to see if it's scale clogging the opening.
I'm getting lots of fizz, but it's still blocked so far.