HK wrote:
Reginald P. Smithers III wrote:
HK wrote:
wrote:
On Dec 12, 10:23 pm, HK wrote:
wrote:
On Dec 12, 6:28 pm, Wayne.B wrote:
On Wed, 12 Dec 2007 14:40:27 -0800 (PST),
wrote:
I am trying to figure out what possible advantage an LT boat
offers.
Why wouldn't they include an engine well, it can't be that
expensive.- Hide quoted text -
- Show quoted text -
When you are trying to arrange 15-25 square feet in a under twenty
foot boat, a couple of feet makes a huge difference...
Wouldn't a 20 ft boat with maybe a 5 or 6 ft beam have something
like
70 or 80 sq ft of working area ?
Not really. The ratio of internal structure is much higher in a
smaller boat. Yaimkool,http://www.yaimkool.commy 16 foot by 6 1/2
foot flat bottom skiff is built around a fiberglass and plywood
laminated transom connected to two 2 x 6 floor stringers. Inside the
hull this is all tied into rear seat boxes that reach 52 inches
forward of the transom inside the hull. I might have been able to
make
the seats a little shorter, but I need room for triangulation in the
seat framework, and room for flotation too. There is also a thwart
midships which is more for lateral structure (and flotation) than it
is for seating. Lot's of folks ask why I did not leave it out for
more
floor space, but that thwart is critical to the boats structural
integerity, as are the thwarts in most smaller boats, say under 20
feet. Likewise the front seat adds crossmembers and another good
triangle in the hull, and provides stiffness to the bow. Triangles
are
good, you will see them all over the inside of most smaller wooden
boats.
Anyway, after all that, and remembering that I probably went a little
overboard as the intended owner was going to put a huge engine on the
rear end, I end up with a little over 21 square feet of floor space.
My seating however is big enough to use as casting decks.
A 20' with a 6' beam?

Wayne is familiar with Pangas?

My 21' boat has an 8'6" beam.

The engine well isn't there because the people who buy these boats
don't
want them. What a d'oh.- Hide quoted text -

- Show quoted text -

A traditional New England semi dory of twenty feet would not be out of
place with a 6 foot beam..


That's very true. Gosh, they had notched transoms, too. Of all the
"boat" discussions we have had here since the demise of Skipper, this
one has to be the dumbest, and perpetrated by a couple of people who
should know better and a few who are dumb and lacking in boat
knowledge as white toast.

One of the most popular boats in Florida is the Carolina Skiff.
They're everywhere, inshore and offshore. Not only do they have no
motor well or splashboard, they have low sides. Maybe Whine and
Reggie should start a patrol to warn the owners of these boats they
are putting their lives on the line.

Harry,

You need to look at Carolina Skiff again. The mfg'er of the boats
doesn't consider the boats with a hole in the transom an offshore
boat. The boat they candider an offshore boat have a high transom and
a engine well. They specifically make a boat for inshore fishing and
one for offshore fishing.

This really is no big deal because you only use your boat in the bay.


Carolina Skiffs are found all over Florida, inshore and offshore. They
have no motorwell or splashboard. I've seen them 20-30 miles offshore on
good weather days, and running the rough inlets, where the conditions
would make a dickstick like you soil your shorts.

You really know nothing.

Harry,
I hate to tell you this, but I have been much further offshore than you.