On Sep 16, 5:05 pm, roger wrote:
On Sep 13, 8:01 pm, Bob Martin wrote:



So I've reclaimed our family's old Lido 14, and I'm going to start the restoration process
on it. The guy that had been "taking care" of it for the past few years let the poor boat
just sit and gather dirt. He sanded the hull down (apparently intending to repaint it),
but never finished the job.

Basically, the rudder and centerboard need substantial work. I've done some fiberglass
work before, so I can reinforce the rough areas and seal the rest with epoxy.

The hull needs some fiberglass work too, especially on the transom (old epoxy has cracked
and started to pull away from the wood in some areas) and the floor of the cockpit. I
also need to replace all of the fittings, which brings me to my questions:

1: How can I repair the cracked transom epoxy? Do I just cut/chip away the delaminating
parts, and reseal?

2: What epoxy/fiberglass combination would work best for all these repairs? I'm used to
using woven plies from doing work on aircraft, but it appears the boat has glass mats that
seem to be just random jumbles of long fibers.

3: How do I repair holes where fittings attached? I have a feeling that a lot of them
have either stripped out or rotted, and I don't want to be putting my mast fitting into
rotted wood. Can I overdrill the hole, plug with a dowel or similar, then glass it in and
redrill the hole?

4: Finally, how should I go about getting the hull repainted? I live in an apartment
complex, which rules out spraying it myself.

Thanks in advance

On the transom and floor of the cockpit, where it is delaminating from
the wood, this is a potential concern for rot. I would pull it off,
chip it off as you say and inspect it for wood rot before reglassing
it. You seem to know how to glass it from aircraft work. I would use
glass cloth and matt with epoxy resin, any brand, to reglass it.

For the holes where the fitting are attached: if the holes are just to
be filled, I would drill them out oversized, back with tape on inside
and fill with a epoxy/filler combination. I like to use epoxy with
fiberglass fibers as a filler. It has good structural qualities but
any commercial filler will work. If you are going to reuse the holes
to attach fittings, I would over drill them, fill them with said
mixture of epoxy/filler and then redrill them to proper size. This is
the most popular way to do it. Forget the dowel idea because the wood
will just rot again.

Repainting in an apartment complex parking lot? I would to the "roll
and tip method" lots of information on this on the net.
Stick with white paint as it flows out the best. You can even get
away with just rolling it on with white if you don't mind a little
orange peel look. It is all just my two cents. Good luck and enjoy
the project!

Just one more thing, before going out and buying what you think you
may need to restore this lido 14, I would consider pulling back all
that delaminating glass to see what horrors may be hiding underneath.
Maybe it won't be worth all the effort and cost? But of course that is
your decision and judgment to make.