when I needed a new tiller someone suggested using a pick axe handle. well
it has worked fine with pickaxe for about three years now.just thought I`d
let you all know
Bri
"dadiOH" wrote in message
news:gYvEi.509$282.86@trnddc01...
Toller wrote:
The rudder/tiller on my Potter 15 is disintigrating, so I will be
asking a few questions on rebuilding it in the next few weeks.
The tiller handle is laminated wood, in a very slight S curve. It
has delaminated; and while I am now gluing it up with polyurethane
glue,
Not a good choice.
______________
It doesn't go over or under anything, so I don't see that the S
curve is for anything but maybe style.
A curve brings the end where your hand goes higher relative to the
rudder stock. Or lower, depending.
______________
Can I make the new one straight?
Yes
_______________
Is there any compelling reason it has to be laminated?
Compelling, no.
_________________
I have a nice piece of very old white oak I can use to cut a new
one;
will a solid white oak tiller handle be inappropriate for any
reason?
It will work fine. It will be rather heavy though. Mine is oak, made
of several pieces. The short & solid hand end is attached to two thin
pieces that are separated at intervals by three tapered blocks between
them. Making it in that manner decreased weight and saved a lot of
the shaping that would have been needed had I used a solid piece.
________________
(I have a bandsaw, so duplicating the curve would
be easy enough, but I think it will weaken the handle,
It would.
--
dadiOH
____________________________
dadiOH's dandies v3.06...
...a help file of info about MP3s, recording from
LP/cassette and tips & tricks on this and that.
Get it at http://mysite.verizon.net/xico