Detroit 353 diesel -- aluminum block? How to tell?
wrote in message
...
On Wed, 22 Aug 2007 12:27:55 GMT, "Pete C."
wrote:
Eisboch wrote:
"JohnM" wrote in message
m...
All two-stroke Detroits have a blower. It's necessary to the operation
of
the engine, does the job that crankcase pressure does in a little
two-stroke. On the inline motors it mounts on the side of the block.
John
If a "blower" is defined by you as a turbo (i.e. .., device to increase
air
flow into the cylinders), then you are in error. I know several people
with
2 stroke DD 6-71's. Some are naturally aspirated, some have turbos
(blowers).
Eisboch
A "blower" generally refers to a direct driven super charger, not an
exhaust driven turbo charger.
The Detroit Diesel is a two stroke, diesel. The piston goes down on
the power stroke and comes up on the compression stroke. Without the
mechanical driven "blower" which simply blows air in through the
cylinder ports and through the exhaust ports at the beginning of the
compression stroke there would be no way to get a charge of air into
the engine.
If you wanted to increase the pressure and volume of this air flow you
could add a exhaust driven compressor before the "blower", But you
must have the "blower" for the engine to run.
Bruce in Bangkok
(brucepaigeATgmailDOTcom)
On large stationary diesel generators using Detroit diesels, there a often
both shaft driven " blowers" and turbochargers.
The blowers are used to start the engine and get it up to speed.
Afterwards, the blowers are cut off by damper valves and the turbochargers
take over the air supply job. This is done because the overall engine
efficiency is better using the turbochargers.
Randy
|