Tom Adkins wrote:
Frank from Deeetroit wrote:
"trainfan1" wrote in message
news
Steve Barker wrote:

http://i17.photobucket.com/albums/b7...c/IMG_0174.jpg
http://i17.photobucket.com/albums/b7...c/IMG_0175.jpg


the 429/460 has valve covers about twice as wide as these and more
than 4 bolts in them. These valve covers are small block chevy.

Sure looks that way.

Did Grey Marine ever use Chevrolet heads on a proprietary block?
This would be the only way to get the distributor drive gear into the
front of the engine as I see it.

That distributor is right where they are on the FE blocks. I can't
think of any common wide block that shares bore spacing &/or bolt
patterns with the SBC.

Anyone?

Rob


Looks like a smallblock chevy that is installed with the front of the
engine facing to the rear of the boat. The water pump and belts look
like they are mounted on the back of the engine and the drive shaft
would be connected to the front of the engine.

Aaaahhhhh, for reverse rotation.

The hard way.

It's easier actually to run the engine backwards.

But this is a good explanation, except again the pics are too small to
see if that is a timing cover or a bell housing(starter & all on
flywheel) behind the water pump.

Rob