On May 22, 8:48 am, Charlie Morgan wrote:
On 22 May 2007 08:09:33 -0700, Chuck Gould
wrote:
On May 21, 6:34 am, Charlie Morgan wrote:
On Mon, 21 May 2007 12:40:25 -0000, thunder
wrote:
On Mon, 21 May 2007 10:52:57 +0000, Short Wave Sportfishing wrote:
They are rolling along now on their counter clockwise Great Loop.
Follow along.
http://dnkcruising.blogspot.com/
Thanks for the link. I was reading that he had an engine problem a
couple of days before they set off. I hate that. If he's anything like
me, he'll now have that little seed of doubt in the back of his mind,
just festering. Man, I hate that.
He's a handy guy. Hopefully, it's fixed and the rest will be smooth
sailing.
When Doug bought that tub, many folks questioned the wisdom of a
single engine. Doug's blustery over-confident reply was that with only
one engine, he'd lavish it with twice as much maintenance. Looks like
that was just more wind.
CWM
Darn good thing you never see a twin engine boat getting towed back to
the dock.
Advantages of twins:
1. Redundancy
2. May be easier to handle in some close quarter situations.
(both are important)
Disadvantages of twins:
1. Fuel consumption is 100% higher at the same rpm, (but often only
about 80% higher
at the same speed)
Really? 2 100 hp engines use twice as much fuel as a single 200hp
engine? Amazing! Who woulda thunk it?
It would be extremely atypical to put in two engines each rated at
half the horsepower of a single application. Performance in many cases
would be *worse* than the single engine alternative, as you would be
trying to move a heavier boat with the same total HP.
4. Exposed running gear. (more people probably lose propulsion because
they have torn off a strut or damaged an exposed shaft that los
propulsion doe to the failure of a pproperly maintained diesel engine)
Bzzzt. Fuel problems occur far more often than tearing off a strut.
Not even close
CWM- Hide quoted text -
- Show quoted text -
Bzzt back at ya..... most fuel problems will disable both engines on a
twin setup. Sounds like Doug had a mechanical problem, ot actually a
fuel problem. Seems like it was with his with his lift pump. That's a
part that works until it fails, not really anything to "maintain"