I splice. First I solder the new wire to the old wires making sure I slip a
piece of heat shrink on the wire first. Then I paint the connection with
that black liquid wire insulation stuff. I let that dry. Then I slide the
heat shrink over that and heat it up.

wrote in message
ups.com...
Hi. I have a 92 Bravo One and my trim limit and sender need to be
replaced. Will a hinge pin tool be enough to flip the bell housing
down to make room to get at the wires? I'd rather not have to remove
the shift cable or bellows. Does anyone have any tips/tricks to
making this job happen without creating other problems? I appreciate
any help, thank you. Kevin D.