Change the impeller AND check the pee hole for any blockages. You must
change an impeller that old.

-W

"Chris" wrote in message
.. .
Hello,

I've recently started into a new project on an older boat, and have been
examining the motor. Today I had it started and running briefly when I
noticed that from the pee hole where water is suppose to shoot out,
instead
it was just dripping ever so slow.

This motor has been out of water, and sitting for much of the last 8 or so
years. Its a 72 80hp 4 cylinder. The guy I bought it from says that
likely
the impeller needs to be changed as it would have dried out... Would that
be
correct? Any ideas? The motor was perfect when it was last used 8+ years
ago...

I don't want to run it too much until the water gets figured out. From
what
I'm guessing without looking into too much detail yet, I have to take the
lower end (gearcase) off to get to this impeller.



Cheers