View Single Post
  #10   Report Post  
posted to rec.boats
James James is offline
external usenet poster
 
First recorded activity by BoatBanter: Jul 2006
Posts: 163
Default Stern Drive Conversion

I suspect you will find it does not have a raw water pump in the outdrive.
The raw water pump is just to supply cooling water to the engine. I gather
you have not taken the outdrive apart. No real reason to if it does not
supply cooling water. You should change it's fluid and check the old fluid
for signs of water.

You need to wire your electric fuel pump to the cranking terminal of the
starter and to an oil pressure switch.

Best of luck with your new boat :-)

"Bennie" u31788@uwe wrote in message news:6ddc6c80655ed@uwe...
Sorry for being a bit slow but I thought there was a potential problem if
the
RAW water pump on the Stern Drive was just ignored....
Hopefully I can learn this stuff quickly.

Bennie wrote:
I don't know......It is stamped redone on the outside of the stern drive.
Is
it OK just to run the Sterndrive without pipes hooked up since the water
route through the Transom goes to a blank off plate? I was worried about
the stern-drive it's self needing cooled.... The boat definitely has a
through hull raw water pickup that flows through the heat exchanger and
out
via the exhaust.
Remember I am OK with anything mechanical (engines, gearboxes etc) but I
am
unfamiliar with the needs of sterndrives....

Converted to what?

[quoted text clipped - 8 lines]
My assumption is that the pre-Alpha drive has been converted
somehow.....!!!!!