I use handy wrap to cover my pvc pipe before repairing. I also try to do
just the outer edge first and also cover it with handy wrap to stop the GOOP
from running. Sometimes the Handy Wrap comes off and sometimes it doesn't.
It doesn't really matter. The best thing is to have some spare seals. Once
one part tears the rest is on its way.

Sincerely,
Carey Robson
www.CanoeBC.ca

"(PeteCresswell)" wrote in message
...
Per Brian Nystrom:
For that matter, you can use tube patches to repair rips and holes or to
reinforce damaged edges. However, it's not difficult to replace the seal
and be done with it.

In the past, I'd been doing my neck seals on the hood of my car: lay it
flat,
use 30-40 little magnets to hold it all together. My best time was
about
45 minutes for a neck seal and 2 wrist seals.

Just did the last two neck seals with the jigs that Kokatat describes: a
ring, a
plate to clamp the ring to, and a smaller plate to give the top of the
seal some
shape.

The wood I cut the jigs from was way too thick - about 3/4"... Didn't put
a
clock on it, but it was pretty impressive how simple the process became
alignment-wise.

If I can find some 1/4" polyethylene sheet to cut another set of jigs
from, I
think it'll be even easier bc the only downside was having to separate the
seals/dryed glue from the wood.
--
PeteCresswell