Cave .. Sheep .. I did a search on the net. Cruising World had an old
article that popped up. Said to use Aluminum, Stainless or Marine Ply.


Casey ,, said to use solid block.

===
"cavelamb himself" wrote in message
ink.net...
NE Sailboat wrote:
Planning for spring. I will rebed my stanchion bases. Under the deck,
the backing is a thin piece of fiberglass. I would like to give the
bases a bit more support. I came across the material Starboard.

It says that I can cut it just like wood, but that it does not rot. What
about compression?

Could I use some small pieces of this as backing plate material for my
stanchion bases?
It would have to be bolted.
(even epoxy wouldn't stick very well)


I'm doing the same thing for two of my stanchions.

But I'm planning to use either plywood or a hard wood block
glassed into the under deck.