Thanks for the reply, Peggie. I appreciate your time! I sent an email
to you privately, but maybe it didn't come across...

You said:

"The v-berth is the ONLY good
location on that boat. Any other location that has room for it is too
far from the head. Route the hose from the Traveler to the tank under
the portside hanging locker (the sole in the locker comes out by just
removing some screws)--which is also a great place to put the
macerator--and then behind the drawers. Run the vent off the tank to a
new vent fitting near the bow...don't bring it back to the existing one
behind the vanity in the head. And make the vent 1".

Do you mean that the hose gets routed through the bottom of the locker
past the v-berth drawer to the tank located in the v-berth? And...that
the pump would be located in the bottom of the locker with the hose?
Someone has been there befo Currently the hoses are routed directly
through the locker (in the back) to a macerator in the v-berth. The
hose from the macerator goes into the bilge and out through a
thru-hull. The macerator (Jabsco 18950) is wired shut - we don't
even know if it works. Looks like we need to:

1. install vents
2. reroute the hose from the macerator to the new tank after verifying
the Jabsco works
3. route the hose from the tank to the pumpout valve.

Does that sound right?

Lastly - why shouldn't we use the existing vent?


Thanks again!

Geri