I used my 3hp router mounted on a table set on a portable work bench and a
$50 Amana finger jointing bit. Stacked a batch of the strips on sawhorses
set at the same level as the table and cut one end of each strip. Then I
moved the router to the other end of the stack and cut that end. Took about
2 days to cut fingers on both ends of 400 16' strips with minimum material
handling.
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at:
http://www.rutuonline.com
Shameless Commercial Division:
http://www.spade-anchor-us.com
"Dave W" wrote in message
...
Has anyone found a reasonably priced shaper cutter for making finger
joints in "planking" for strip built boats? Thanks in advance
Dave