Used Y pipes go for under a $100 on ebay all the time. Anyhting for a
boat that's under a $100 is a bargain :-)

Knucklebuster wrote:
rob wrote:
I'm not sure if the Bravo is similar to the alpa1 or not, but I had the
o-ring on the water pick up port go bad and had the exact problem.
When the engine was running, it was actually pumping water into the
main bellows and filling up the bilge. When the motor was not running,
there were no leaks. It would also pump a very small amount of water
through the shift cable and onto the top of the motor.

Has the out drive been removed recently? If so, maybe the o-ring is
pinched....

I had the drive off the replace the engine, but is water is warm so I
don't think it's coming from the pickup. Never the less I have to pull
the drive to get the engine out, so I'll be sure to take a look at
everything very closely. I'm hoping it's just the Y pipe gasket that
Jim was talking about. If not I'll have to break into the ole piggy
bank again. Thanks!