"Jim Kelly" wrote in message
...
Water plugs.

Jim Fitzpatrick wrote:

I am de-winterizing an OMC 5.8L with a Cobra drive.
There are three plugs on the upper drive. Two on the starboard side, one
on
the port.
Are these just drain plugs for water or for lubricant?
I am familiar with Merc which don't have these extra plugs (threaded).
This my first Cobra.
Any help?
Thanks
Fitz



Do not touch or remove the large slotted plug on the port side of the
outdrive. That is normally covered by an emblem and not visible. If you
remove it, the threaded retainer inside the water passage will fall and the
outdrive will have to be removed to re-install it. That plug covers a
drilled hole for a water passage that was done during the machining of the
raw casting.

On the starboard side, you should have 2 slotted gear oil plugs, if your
Cobra outdrive is between 1985 and 1995. You drain the oil thru the bottom
plug on the lower gearcase. To full the unit, install the bottom drain plug
and fill thru the MIDDLE plug until the oil reaches the dipstick plug on the
top of the drive. Get a service manual for outdrive for a better explanation
and illustrations.

Bill Grannis
service manager