"RW Salnick" wrote
Assuming we are talking about a 2GM, displacement of say 600 cc, idling
at 1000 RPM, it is pumping 0.6/2*1000 = 300 liters/min of air out the
exhaust pipe. This is approximately 10 CFM - not bad for idle and a
small engine...

bob,
If the 2GM is a 4-cycle engine, is the above correct if it only draws in
air every other revolution?

Shouldn't air flow to engine room be calculated to keep temperature down ?
As the combustion air temperature goes up, engine efficiency goes down - I
read somewhere that power loss could be 11% if temperature rises from 80F to
150F.

Perhaps having the exhaust fan run all the time the engine runs would be a
good idea?

GBM