Andrew Butchart wrote:
"frOg" wrote in message
newsAjhg.13035$523.5422@trnddc07...

wrote in message
oups.com...
I would like to know whether eight toggle bolts (such as the one from
FASCO Fastener) are strong enough for bolting down a seat (like a
seat/cooler combo unit). Currently, the seat is only screwed into the
core material of my deck and the core material is totally rottened. I
will add epoxy bedding to strengthen the fasteners area of the deck,
and I want to use bolts instead of screws to secure the seat. The
problem is that there is no access to the underside of the deck where
the seat is (the boat is a small 18-ft power boat). And I cannot get
my hand into that area through a nearby inspection hole because there
is a structure frame blocking my way. I am wondering if the
toggle-bolts are a good way to secure the seat in my situation.

But I normally don't use toggle bolts for anything other than hanging
pictures, towel bars that sort of things. I am not sure if toggle
bolts are strong enough to secure a seat. I saw someone used toggle
bars in a boating TV show; but that was for securing a battery, not
anything too heavy. I am wondering if this is a good choice...

Thanks in advance for any info.

I went onto the FASCO web site and they don't have any pictures of their
stainless steel marine toggle bolts. I've used toggle bolts in concrete
with limited success - what I've found is that it really depends on how the
bolt will grab on under and into the surface you are attaching to, and how
strong it is. I don't know if the un-reinforced layer of fiberglass would
be solid enough.

--
Andrew Butchart


Seem like I have left out too much info about the toggle bolts that I
was talking about. Sorry about this.

Despite the fact that both the manufacturer and the mail order place
call these "togglers", these togglers look quite different from the
conventional toggle bolts that we use for securing a towel bar onto dry
wall. This type of togglers has a metal plate with a threaded hole at
the center (this serves as both a backing-plate and a nut), and there
is a plastic strip connecting to the metal plate, as shown he

http://www.westmarine.com/webapp/wcs...allpartial/0/0

(You can reach the same page by searching for "fasco togglers" in West
Marine web site).

The idea is to drill a hole on the deck just big enough to insert the
metal plate through the hole, and we hold on with the plastic strip.
By pulling the plastic strip tight, the metal plate is pressed against
the underside of the deck, and the threaded hole will be aligned with
the hole on the deck, and we can insert a bolt through the deck hole
into the threaded hole of the metal plate. This way we can connect the
bolt to the metal plate (that is under the deck), and then we can cut
the plastic strip away (it has served its purpose). This is the idea.

Yes, I have checked FASCO web site. But they don't have any picture,
nor any specification as of how much strength their togglers can
provide. This is the reason why I want to ask around here to see if
anyone has personal experience about this type of togglers.

I intend to put a layer of thick solid fiberglass with epoxy to replace
the core material in the area where I will bolt the seat onto.
Hopefully, this will be strong enough.

If the idea of using togglers doesn't work, I will have to permanently
mount a backing plate (with nuts welded on it) onto the underside of
the deck; I will have to open up the deck to replace the rottened core
material anyway, and I can cut open the inner skin of the deck and
repair it later. But aligning the holes of the buts with the mounting
holes on the seat can be a big challenge, and I am not looking forward
to this.

Jay Chan