I printed it all out several years ago when I was designing my system but
can't find the paper anymore. They looked like part of the owner's manual
so you might try to find someone with a system.

--
Glenn Ashmore

I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com

"Brent Geery" wrote in message
...
Hi Glenn,

Do you happen to still have a copy if the info you mention below? I
know a penny-pinching mad scientist type that would be interested in
the challenge of building on of these.

On Wed, 17 May 2006 12:20:10 -0400, "Glenn Ashmore"
wrote:

At one time Spectra had an exploded parts sketch and a parts list with all
the o-ring dimensions that was enough to reverse engineer it but I think
they took it down after I pulled out my calipers at Annapolis a few years
ago to get a few last dimensions. :-)

--
BRENT - The Usenet typo king.