GBM wrote:

"Don W" wrote


Several knowledgeable people have mentioned that marine engines exposed
to salt water corrode from the inside out, and it makes sense. Right
now, the engine seems to be in fine shape, but my nagging worry is about
how thin the iron around the water passages may be. Since it is cooled
by salt water, it seems that they are probably not only thin already,
but getting thinner--thin being a relative term of course. My thought
on adding FWC would be to run a 75%/25% mixture of antifreeze and fresh
water which would stop the block from getting any thinner.



Don,

At one time almost all engines were seawater cooled - Those older Yanmars
were much heavier than the later GM series and likely had much thicker wall
thicknesses. They are also equipped with anodes to reduce corrosion - Not
sure how many owners actually change these though - When we bought our boat,
I changed the anodes - they were partly used up, but still serviceable.
Might be worth checking to see if yours were replaced during rebuild. In the
early 80's, there was a drive to get lighter engines for sailboat use, and
the GM series provided that. And, most of the larger GM engines were
equipped with closed circuit cooling.

Our own boat has a 1978 Yanmar 2QM15 direct cooled. It spent most of it's
life in salt water - Never been overhauled and still runs perfectly.

Hey, that's my exact motor. Maybe we should form a club!


--
Stephen

-------

For any proposition there is always some sufficiently narrow
interpretation of its terms, such that it turns out true, and
some sufficiently wide interpretation such that it turns out
false...concept stretching will refute *any* statement, and will
leave no true statement whatsoever.
-- Imre Lakatos