Don't know where you are located, but if close to Ft. Lauderdale, you
can contact Mark Malo at
http://www.fort-lauderdale-marine-di...m/dir/c/38.php
He takes old Perkins in as exchange, rebuilds to rebuildable and parts
out the rest. Also will probably be available at Transmission Marine
http://www.marinegears.com.
Kelton
s/v Isle Escape

Skip Gundlach wrote:
I'm looking for the plate which bolts to the tranny with 4 bolts with their
heads facing the engine, about 4" apart at the top and bottom pairs and
perhaps a little less in height (on the port and starboard height
separations), and to the bell housing with 6 bolts, 3 each on the starboard
and port sides, with their heads facing the stern.

It's circular, essentially flat (with some web bosses), about 11" in
diameter. There's also a couple of what look like potential bracket
mounting bosses on the top section (above where the tranny bolts to it, on
the outside, facing the tranny) of about 1/4 centers, about 4" apart. As
mine weren't used, they're not important, but might help identify the part.

Likely this mount was used in all Perkins 4-cylinder to Hurth trannies, but
I don't know that for certain, at all.

Anyone have one from a junk/pull, or know where I should look?

Thanks.

L8R

Skip and Lydia