Full agreement to Anons answer and would add following

I use sable saw, skill saw (one stationary) and a saber saw.
All has carbide tips or are hardened blades, it pays back.
For the skill saws, the tips should be sharpened for Aluminum, is a little
difference compared for wood.
If they are clocked, remove the alu very carefully but gentle, not to hurt
the tips and their connection.
Even use a thin file to loosen the alu-bit and a sharp-edged nipper.
(I have already destroyed 2 Blades)

Use protection glasses and gloves, alu-chips are hot and sharp

I use wax, it works ok, aswell as lubricating oil (it's for lubricating
lathes).
Both works much better than no lubrication.
The only disadvantage is for welding, therefore I have to clean thoroughly.

klaus

--------------------------------------------
if interested, but only german www.aluriverboat.de



I use skill saw, sable saw and carbide tips
"anon" schrieb im Newsbeitrag
...
On Thu, 23 Mar 2006 21:28:57 -0500, "Jim and Becky"
wrote:

I own a 32' fishing boat.
The superstructure is 3/16th aluminum. I want to saw out the port
wheelhouse
wall as I convert the boat into a family cruiser.

I intend to use a carbide tipped blade made for aluminum on a 7 1/4"
skill
saw.

I'm wondering about lubrication. I've read parrafin wax would work. How
much
do they mean? The amount you'd rub on a snow ski or an 1/4" mound of the
stuff?

Does anyone think the skill saw idea is bad?


Aluminum is a soft metal and can be cut with about anything. In fact
you could use a hand saw with a fine tooth blade.

Using power tools You will encounter two problem areas.

First, heat buildup caused by friction. A skill saw intended for
cutting wood may have a higher blade speed then ideal for cutting
aluminum.

There second problem you may encounter is that if the aluminum is one
of the softer variates it will tend to clog the saw blade.

I would suggest, if possible, you use a sabre saw with variable
speed.. High speed steel blades will be quite adequate. You don't need
carbide tips although if you do use the skill saw the carbide tips
will withstand the heat better.

The ideal lubricant to use is "Tap Magic" which is a product developed
for tapping screw holes and it really does work like magic. Just be
sure to specify that it is for aluminum.

If you don't want to go to the bother of locating tap magic a
"secret" I was taught during my apprentice days was to use kerosene or
diesel fuel as a cutting fluid for aluminum. Use a "squirt can" and
give it a squirt from time to time.


Anon
)
_________________________________________
Usenet Zone Free Binaries Usenet Server
More than 140,000 groups
Unlimited download
http://www.usenetzone.com to open account