"DSK" wrote in message
...
Scotty wrote:
I took a Skinner, single cyl., horizontal steam engine out to
IN
last week. I think it's a Multi Flow.
These are the 3 big pieces to it. The smaller stuff will come
later.

http://www.enter.net/photoalbum/data...non/920863.JPG
http://www.enter.net/photoalbum/data...non/525767.JPG


The crank / flywheel / rotor assy. Weighs 9 ton.

http://www.enter.net/photoalbum/data/sbvernon/38778.JPG


This is the sister engine, one serial # apart. We set this
one up
about 10 years ago.
It's very dark in the powerhouse, so most pics came out too
dark.

http://www.enter.net/photoalbum/data...non/621374.JPG
http://www.enter.net/photoalbum/data...non/197707.JPG



Thanks Scott. I haven't seen any like that, looks like the
slide valve is built into the bearing housing. What's all
that stuff in the middle of the flywheel do?


that's the governor.


Sure looks heavy!


This is the smallest steam engine I've handled. The bigger ones
are around 50 ton. Those 3 pieces were 20 ton. The whole engine
weighs 35 ton. I hauled a complete engine once because I didn't
want to go back to Long Island a second time.

Scotty