Chris wrote:

I've got some visible cracks at the bottom of my hull on my 16ft
runabout. This past summer when using the boat I was getting a bit
of water in it after having it sit for a while in the water (the
bilge pump easily took care of it). I'm now thinking that these
cracks may be the cause and water slowly seeps into the boat.

Now, my question about how I should attempt to fix this giving the
following considerations 1. It's an old boat. 2. I use it a 4-5
weekends a year. 3. I don't want to spend a lot of money as its not
worth it.

snip

Based on the above, you need a functional repair, but this is no gold
plater, so the finish of the repair can basically be slim or none;
however, the repair should do a proper job.

My solution will be prejudiced since I run an epoxy shop.

IMHO, polyester is for shower stalls, not boat repairs.


1) Buy a 1 qt kit of laminating epoxy, a yard of 17 oz biaxial, knitted
glass, some 2" chip brushes and some latex gloves.

2) Flip boat upside down and grind back from the crack about 4" using a
24 grit, right angle sander. Leave the sanded surface ROUGH, the rougher
the better.

3) Lay 2 layers of 17 oz glass using the 2nd layer to over lap the first
layer about (1")-(1-1/2") all around.

4) Let cure 48 hours, then scuff up with 24 grit sander and lay 2 more
layers of 17 oz glass as above.

5) Wait 48 hours then fair edges of patch fair with boat using 24 grit
sander.

6) Flip boat over, scuff up inside and lay 2 layers of glass, same as
outside.

7) Get a beer, maybe 2.

8) Allow inside patch to cure about 72 hours, then relaunch boat and enjoy.

Notice the lack of labor intensive finish work?

OK, if you are fussy, fair out edges of inside patch, otherwise, forget it.


Lew