On 28 Sep 2005 13:34:37 -0700, "bob" wrote:
Hello Steve:
Thanks for the reply. 3'x5' chain plates? Must be a big rig?!?
I'm not looking for an argument here. Just trying to muck my way
through boatbuilding tradition. I'm sure you've found in a few
insistences that the reason it is the "best way" is because they have
always did it that way. Time marches on and so do innovations. I may
very well find myself going with a polysulfide. But.....
However, I am hoping there is something "better" than polysulfide and
5200. My big question is: why does 5200 fail? You mentioned that it
does not take a squish very well. I know that 5200 can not handle temps
over 150 well. 3Ms data says 5200 can elongate 1300% with out
failure. So the pull in a gap should not be the problem. May the
problem is in the pinch?
Why do you say that 5200 can not take a squish? Is it damaged and lose
the bond??
Have you ever heard of Silaprene or used it?
Still in search
Hi,
Are you talking about bedding chainplates on the outside of a hull or
sealing where they pass through a deck?
For bedding I'd use eg 5200, mold release wax and some sort of spacers
to create a gasket, then seal the gasket and bolts holes/threads with
a sticky non setting compound.
I'd expect most problems occur where something is used to bed stuff
which is then tightened down too much initially, leaving a layer that
is too thin to take any movement and cannot be compressed further.
cheers,
Pete.
|