Well.. not frozen it wiggles a little but it is like it is engaged to both
forward and reverse at once


"Mark" wrote in message
...
I had it in forward like you say, but the driveshaft is frozen and won't
turn to allow the splines to line up. Drive shaft wont turn in forward
nuetral or reverse. The propeler shaft does though.

Mark

"Gorf" wrote in message
m...

"Woodchuck" wrote in message
.. .
I think the drive must be in forward to remove & install the drive.


Right you are, and you have to careful that the square shifter fork on
the
right side remains upright while sliding the outdrive on, if it twists
from
the upright position, it will not engage. You can check by raiseing the
drive and moving the shifter, there is a fork that you can reach from
underneath- you should feel it move. Should be straight forward when
the
shifter is forward.



"Mark" wrote in message
...
Hi Guru's,
I took off the foot to install the new waterpump. I had
difficulty
getting it back on and noticed that the prop won't turn the drive
shaft
no
matter what position I have the shift shaft in. When I was removing
the
prop, it moved backwards and clicked a time ot two when I was
getting
it
into position to wedge the block. Any idea's on what the problem
might
be?

Thanks, Mark