My Merc out drive tilts up and is stuck in the up position (both the
trailer switch and the trim switch mounted on the throttle work).
However the down does not do anything (no sound, solenoid click,
nothing). I have ohm'ed out the switch and it is working as it should.
I have ohm'ed the other direction and it appears to be an open
(possibly an open wire). I am not sure where this equipment physically
is located to check this out, nor do I have shcmatics showing me which
wire is which - anyone have any experience here? Also the lower
portion of the engine/ starter were under water for a while. The
starter has been replaced and I wonder if they left a wire off or broke
it or it is just plane corroded? Thanks for your help in advance.
Steve