Thread
:
BCU sticker doesn't stick
View Single Post
#
5
Peter Clinch
Posts: n/a
wrote:
You are going to hate this.
The only way you are going to make a sticker stick to a dimply rough
surface is to flatten it.
Though you can bring the surface /up/ by just using a sufficiency of
contact adhesive that it can fill in the "grain" of the hull. A bit
messy compared to just sticking on a sticker, but it should work and you
shouldn't need anything too fancy, just a general purpose household
adhesive should probably do (it's only holding on paper, so it's not
like it's structural).
caveat: I haven't done this myself so don't take responsibility if it
goes wrong, and won't come and sand failed attempts off your boat!
Pete.
--
Peter Clinch Medical Physics IT Officer
Tel 44 1382 660111 ext. 33637 Univ. of Dundee, Ninewells Hospital
Fax 44 1382 640177 Dundee DD1 9SY Scotland UK
net
http://www.dundee.ac.uk/~pjclinch/
Reply With Quote