Have a guy coming from Nashville Wed to look at it. I think it is sold. I
just can't use it right now so I don't want it laying around.

--
Tony
my boats and cars at http://t.thomas.home.mchsi.com

-
"Woodchuck" wrote in message
...
Tony, did you ever sell your 21' Eliminator yet? I sold my STV Euroski and
purchased a 1990 21 Skater! Just about ready to run the 300PM after a
complete overhaul.




"tony thomas" wrote in message
news:kFyfe.67380$c24.3956@attbi_s72...
1. If you are wanting to know what a different prop will do for your
speed. Most know that a 2" pitch change will be about 300 rpms.
2. If you want to know how accurate your speedo is. I have found that
most aluminum props are about 85% efficient. Performance SS is about
90%. A High performance prop like a Merc Lab, Mazco, etc.. are about 92%.

These are just examples. I use the formula all the time. When someone
says they have a 150hp engine that is turning 5500 rpms w/ a 22 pitch
prop and running 80 mph you know they are lying. 61.27 is theoritical
and w/ a good prop at 90% they would be at 55 mph.
Now a lot of speedometers will show 80 mph. Without a GPS the formula is
the only way to really know.

--
Tony
my boats and cars at http://t.thomas.home.mchsi.com

-
"Peter Aitken" wrote in message
om...
"Woodchuck" wrote in message
...
For me, it works very well as my props have about 8% to 10% slip and
it's verified by GPS. But then again I'm running a hi-performance boat
over 100mph. The props I have are Mercury stainless steel lab cleavers.
Most average consumer props have alot 15% slip for stainless steel and
near 20% for aluminum. The calculation provides a good starting point
when you want to change pitch, RPM, mph, etc

No one has asked the obvious question - why would anyone want to
calculate boat speed this way?

--
Peter Aitken