On Sun, 8 May 2005 19:53:28 -0700, "Bob La Londe"
wrote:

"Shortwave Sportfishing" wrote in message
.. .
On Sun, 08 May 2005 13:48:52 GMT, "Doug"
wrote:

PT-130

I've never used one, but I have seen them installed on older boats
w/older motors sans trim and tilt and on new boats like the tiller 620
that Ranger makes - they seem to work.

I have never heard anything bad about them. Just remember that this
is a compromise add-on and you should be fine.

Good luck.

I have a CMC jack plate on one of my boats. Not a power tilt/trim product,
but it is good wrokmanship. However, I have heard from two different boat
setup guys that Bob's Machine makes better jacks. Might check and see if
they have a tilt and trim product.

Hey Bob - one of the guys I fish with has a Bob's Machine jack plate
on his Ranger - very impressed with the workmanship. I had one of
their foot cushions on my last Contender - good product.

Later,

Tom